Rj45 Connector

PowerFlex 4-Class DSI RJ45 Terminal Blocks - RJ45 two position terminal block (6 pieces) with two 120 Ohm terminating resistors (loose)
PowerFlex 4-Class DSI RJ45 Terminal Blocks - RJ45 two position terminal block (6 pieces) with two 120 Ohm terminating resistors (loose)
Terminal Block Kit,2 Position,RJ45,with (2) 120 Ohm Loose Terminating Resistors,6 Pieces,Drive Communication
AK-U0-RJ45-TB2P Allen-Bradley PowerFlex 4-Class DSI Terminal Block

Allen-Bradley AK-U0-RJ45-TB2P 6-Piece 2-Position RJ45 Terminal Block Kit With (2) 120 Ohm Terminating Resistor, For Use With: PowerFlex® 4, 40, 40P and 400 AC Drives

Product DescriptionThe AIC+ advanced interface converter provides a communication link between various networked devices. The AIC+ interface converter is compatible with a variety of SLC and MicroLogix controllers and peripherals.

MicroLogix 1000, 1200, and 1500 controllers provide power to the AIC+ interface converter via the RS-232 8-pin mini-DIN port’s cable. However, if a MicroLogix controller is not connected to this port, a 24V dc power supply connected to the converter’s external power terminals is required. The dc power-source selector switch needs to be set for your particular configuration.  

The communication-rate selector switch is used to match the communication rate filter of the AIC+ interface converter to the network communication rate. This switch does not change the network communication rate and is normally left in the AUTO position. In high noise environments, the communication-rate selector switch should be taken out of the AUTO mode and set to the same communication rate as the network.